Macrosystem Columbus 2 Manuel d'utilisateur télécharger pdf (Page 17)

4. Notes on the Power Key Option

Besides providing shortcuts for the existing controls that you can access using the „F2“ key, Colum-

bus 2 also provides a whole range of further functions that to some extent are only available using

the keyboard. The various control options that can be accessed using the keyboard are only availa-

ble if the Power Key Option is activated.

They are listed in the table below.

Key combination (s) Description

Ins This key creates a new waypoint and conﬁgures it with the default values.

To set the waypoint, you must place the trackball pointer over the required

position on the route.

Ctrl Ins This key combination creates a new key point and conﬁgures it with the

default values (trackball pointer must be placed over the position on the

route).

Del The currently selected waypoint or key point (green) is deleted. Starting and

ﬁnishing points cannot be deleted.

Ctrl c This command copies the settings for the currently selected point into an

internal memory buffer (”clipboard“).

Ctrl v This combination applies the values that you previously copied using

<Ctrl c> to the currently selected point.

Ctrl i This creates a new point using the values that you previously copied using

<Ctrl c> (trackball pointer must be placed over the position on the route).

Ctrl s The currently selected point changes state from “way point” to “key point”

or vice-versa.

Enter The currently selected point (green) is activated (turned blue) thus allowing

you to move it. To move it, you can use the cursor keys while pressing and

holding down the <Nav> key (compare also <Ctrl Nav Cursor> in the Power

Key Option manual). After you have moved the point, you can “drop” it in

position by pressing <Enter>.

Esc You can cancel moving an active point (blue) at any time by pressing <Esc>.

The point turns green and jumps back to its original position.

Home The starting point of the route is selected (green).

End The ﬁnishing point of the route is selected (green).

Pg Up 5 The next point along the route towards the starting point is selected (green).

Pg Dn 6 The next point along the route towards the ﬁnishing point is selected

(green).

F13 Preview - even if the toolbar has been minimized.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Pas de commentaire

Macrosystem Columbus 2 Manuel d'utilisateur Page 17